Posted by: manoj18 ® 03/27/2007, 10:29:33 Author Profile eMail author Edit

I am machining 3/4" NPTF threads on the inlet & outlet of a aluminum diecast component. What should be the minimum wall thickness at these ports so that the threads are not weak? thanks, manoj

Replies to this message

Re: WALL THICKNESS OF PORT
Re: WALL THICKNESS OF PORT -- manoj18	Post Reply	Top of thread	Forum

Posted by: Olly ® 03/27/2007, 12:39:55 Author Profile eMail author Edit

Medium engage in steel =~ 1/4", then in aluminum x1,5= ~3/8"; Is not possible to thread over 1/2". By

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

Where am I? Original Top of thread