Universal Tees (T) Split from UC Section Calculator

Universal Tees (T) Split from UC per BS EN 10365 Euro Code 3 Section Properties Calculator. UC = Universal Column

Universal Tees Split From Universal Beams Calculator

Universal Tees (T) Split from UB per BS EN 10365 Euro Code 3 Section Properties Calculator

Universal Back to Back Unequal L Angles Section Properties Calculator

Universal Back to Back Unequal L Angles (L) per. BS EN 10365 Euro Code 3 Section Properties Calculator. The following design data to Eurocode 3 (in accordance with the UK National Annex):

Universal Back to Back Equal L Section Properties Calculator

Universal Back to Back Equal L Angles (L) per. BS EN 10365 Euro Code 3 Section Properties Calculator. The following design data to Eurocode 3 (in accordance with the UK National Annex):

Universal Unequal leg Angles (L) Section Properties Calculator

Universal Unequal leg Angles (L) per. BS EN 10365 Euro Code 3 Section Properties Calculator

Universal Equal leg Angles L Section Properties Calculator

Universal Equal leg Angles (L) per. BS EN 10365 Euro Code 3 Section Properties Calculator

Universal Parallel Flange Channels Properties Calculator

Universal Parallel Flange Channels BS EN 10365 Euro Code 3 Section Properties Calculator

Universal Bearing Piles Section Properties Calculator

Universal Bearing Piles BS EN 10365 Euro Code 3 Section Properties Calculator. The following design data to Eurocode 3 (in accordance with the UK National Annex):

Universal Columns Section Properties Calculator

BS EN 10365 Euro Code 3 Universal Columns Section Properties Calculator. The following design data to Eurocode 3 (in accordance with the UK National Annex):

Universal Narrow Beams Dimension Data

BS EN 10365 Euro Code 3 Universal Narrow Beams

Pad Foundation Design per Eurocode 2 Equations and Calculator

Pad foundation design, Geotechnical design calculations include: Allowable bearing capacity by Brinch Hansen, Preliminary sizing of pad footing, Ultimate bearing pressure, Flexure design, Determine K for respective MED

Steel Column Design per. EUROCODE 2 Calculator and Equations

EN Eurocode 2 is concerned with the requirements for resistance, serviceability, durability and fire resistance of concrete structures.

Reinforced Concrete Flat Slab per. Eurocode 2

Flat slab design Flexure design Column strip and middle strip

Reinforced Concrete Beam Design per. Eurocode 2

EN 1992 Eurocode 2 applies to the design of buildings and other civil engineering works in plain, reinforced and prestressed concrete.

Welded Steel Chain Specifications

These specifications cover properties and grades of welded steel chain for industrial and commercial uses produced to accepted commercial tolerances.

Flammability Limits of Gases in Air

The lower and upper limits of flammability indicate the percentage of combustible gas in air below which and above which flame will not propagate.

Natural Stones Physical and Thermal Properties

A stone or a rock is a naturally occurring composite of minerals. Stone has been used for thousands of years as a major construction material because it possesses qualities of strength, durability, architectural adaptability, and aesthetic satisfaction.

Wood Strength and Related Engineering Design Properties

Properties of Wood at 12% Moisture Content (Average Values from Tests on Clear Pieces 2 x 2 inches in Cross Section per ASTM D143)

Mechanical Properties of Copper Wire

The most common copper is C11000 - electrolytic tough pitch. Its electrical conductivity exceeds 100 percent IACS and is invariably selected for most wire and cable applications.

Copper Temper Designation Codes

ASTM B601 Temper Designation Codes for Copper and Copper Alloys. Copper and copper alloys constitute one of the major groups of commercial metals