Calculator Combined Offset Link, Rectangular Section, in Direct Tension Stress

Beam Deflection, Stress Formula and Calculators

Beam Stress and Deflection Calculations for Non-Engineers

Combined Loading on Circular Shaft in Direct Compression and Torsion Equation and Calculator:

---

Maximum Nominal Tensile or Compressive Stress

---

Maximum Nominal
Shear Stress

---

---

Where:

d =	Diameter	inches	(mm)
T =	Torque Load	inches	(mm)
F =	Applied Load	in-lbs	(mm-N)
σ' a =	Stress, Tensile or Compressive	Lbs/in2	(N/mm2)
τ'a =	Stress , Max. Nominal Shear	Lbs/in2	(N/mm2)

References:

1. Any Machinery's Handbook published since 1931 or,
2. Machinery's Handbook, 21st Edition, Page 404 or,
3. Machinery's Handbook, 23st Edition, Page 260 or,
4. Machinery's Handbook, 27st Edition, Page 261

• Axial Load Capacities for Single Plates Calculator
• Beam Bending Equations / Calculation Supported on Both Ends Uniform Loading
• Beam Bending Equations / Calculation Supported on Both Ends Single Load at Center
• Beam Bending Equations / Calculation Supported on Both Ends Loaded at any Location
• Beam Bending Equations / Calculation Free and Guided on One End, Rigid one End With Uniform Load
• Beam Bending Equations / Calculation Supported on Both Ends With Overhanging Supports of equal Length and Equal Loads
• Beam Bending Equations / Calculation Supported on Both Ends Loaded Two equal Loads
• Beam Bending Equations / Calculation with Ends Overhanging Supports and a Two Equal Loads applied at Symmetrical Locations
• Beam Bending Equations / Calculation with End Overhanging Supports and a Single Load
• Beam Bending Equations / Calculation Cantilevered Beam with One Load Applied at End